3d prints done on the updated printer

The photos show a 3d print made on my updated dlp based 3d printer. The lines on the print represent well defined 0.1 mm layers.  The layers stand out because I printed the part at an angle to minimize large flat faces of the part having to separate from the vat floor. The photos also show the support structure I used which were created using Creation Workshops auto support generator. The part is 86mm X 70mm X 19mm without the supports. Printed with Makerjuice SubG+ yellow resin and Creation Workshop RC3 software.

3d print image 100_1776

3d print

3d print

HL

 

This entry was posted in 3d printing. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *